QCM inks have the largest range of glitter inks available!

Mesh counts 40 - 80 recommended. Screen should be set off-contact to allow ink to separate from screen with each stroke. Higher tension screens give better results.

Glitter Ink should be printed LAST, unless followed by flash curing; multi colored designs can be printed this way.

Use medium/hard squeegee. At least three (3) strokes for full opacity. Use low angle squeegee strokes. Cure @ 325 to 350 degrees F, approx 90 sec. Curing may vary with ink deposit, fabric and type of drying unit. ALWAYS TEST BEFORE USING.

Can be extended with QCM LFP-1002 Clear for non-opaque effects, and cost reduction.

Interesting special effects can be achieved by various contrasting, flash-curing, under-coat colors, under-coat must be properly cured as it may effect the washability of glitter ink) i.e. gold over black (LFP-901); silver over medium blue (LFP-502), etc. Contrasting outlines can produce nice effects when art work for glitter is cropped back.